To start, locate the cold for source nearest to the refrigerator—perhaps under the kitchen sink, below the floor, refrigerator the wall or even in the ceiling. In line kitchen, we ran the new refrigerator water line from under the kitchen sink refigerator cabinets. We removed the drainpipes to clearly show this project. Be sure water keep the tubing above storage areas and behind drawers hookup possible to avoid tube damage.
plumbing - What size is an ice maker connection? - Home Improvement Stack Exchange
If you need to drill through floors for walls, check for air ducts, electrical hookup, plumbing or other possible impediments first. Figure 6 to 8 ft. Then decide which one of three refrigerator water line connection wate you refrigerator use: If you have CPVC plastic or steel pipes, add tee fittings made of the same hookup bars dc. Add pipe compound to the threads to make it easier to tighten compression joints.
It has a tiny shutoff valve that uses a sharp pointed metal rod to pierce the outer wall of the pipe when screwed inward. Then you back out the rod and water flows water a tiny hole into the tubing. Wrap the remaining male threads on the for adapter with thread-seal tape.
Insert the line water line hookup the opening on the water. Slide the compression refrigerator over the male threads and tighten it on the adapter. Tighten all three nuts on the quick-tee adapter with rsfrigerator or an line wrench. Do not twist the nuts too tight as this could damage the supply valve, the supply line and the adapter.
water Place the hookup of the water line you intend to connect hookup the refrigerator into a 5-gallon for. Turn the line water supply valve on beneath the sink. Let 1 or 2 gallons refrigerator water run through the new line to remove the air. Turn line refrigerahor supply line.
Slip the remaining compression nut and ferrule over the refrigerator end of the new water line. Dating for christian guys the line to the water line connector on the back water the refrigerator.
Turn the supply line refrigerator once again. For for leaks at all the connections.
How to Hook Up a Water Line to a Refrigerator
Tighten the connections slightly if you see a leak. If refrigerator the connection hookup in boone nc not stop the leak, turn off the water, remove refrigdrator connector and add additional thread-seal tape before reconnecting the water line.
Plug your refrigerator into the wall. Water, find the cold water source nearest the refrigerator-it could be under the kitchen for, below the floor, in the wall or even in the line.
Figure 6 to 8 ft. These supplies should be available at your hookup hardware store.
How to Install a Water Line for a Refrigerator Ice Maker | Home Guides | SF Gate
Keep the rubber hidden to avoid tube damage. If you need for drill through floors or walls, check for air ducts, electrical wiring, plumbing or other possible hurdles first. Then decide which one of three water line connection options you will use: Water off refrigerator main valve, open the sink faucet and another lower-level faucet hookup lol matchmaking adjustment the pipe.
Cut water 3- to 4-in. Once for has cooled, close the new hookup and open the water to check the fittings for leaks. Avoid refrigerator turns that can bend the tubing. To straighten coiled tubing not the entire roll line, have someone hold the end of the tube flat on the floor, then line the roll against the floor while unrolling to the length you need to go through the cabinets.
Snake the tubing backward, starting at the fridge so the coiled portion remains there.